Accessories

Display: 1-24 from 178 products

1
Phoenix Inverter Control VE.Direct
  • Brand: Victron Energy
Description

This panel is for all Phoenix VE.Direct inverters.
Read more
29.77 EUR VAT included
The product is in stock
Details
2
Orion-Tr 24/12-10 (120W) DC-DC converter
  • Brand: Victron Energy

High efficiency

Using synchronous rectification, full load efficiency exceeds 95%.

IP43 protection

When installed with the screw terminals oriented downwards.

Screw terminals

No special tools needed for installation.

Models: 24 Volt

Read more
42.87 EUR VAT included
The product is in stock
Details
3
M8 circular connector Male/Female 3 pole cable 2m (bag of 2)
  • Brand: Victron Energy

M8 circular connector Male/Female 3 pole cable 2m (bag of 2)

 
Read more
44.06 EUR VAT included
The product is in stock
Details
4
Busbar to connect 5 CIP100200100
  • Brand: Victron Energy

Busbar to connect 5

 
Read more
46.44 EUR VAT included
The product is in stock
Details
5
Smart Battery Sense long range (up to 10m)
  • Brand: Victron Energy

Voltage and Temperature sense

Smart Battery Sense is a wireless battery voltage and temperature sensor for Victron MPPT Solar Chargers.

With voltage and temperature sense in place, batteries will be better charged; improving charging-efficiency and prolonging battery life.

Improves battery charging

By measuring voltage at the battery bank terminals, errors arising from voltage-loss due to cable resistance are avoided – guaranteeing the correct charge-voltage.

For lead batteries, battery temperature data is used to adjust the charge-voltages: cold batteries require an increased charge-voltage, whereas hot batteries require a decreased charge-voltage. For lithium batteries temperature data is used to disable charging when they are too cold: charging lithium batteries near or below freezing causes permanent damage to the cells.

Look no wires

The connection between Smart Battery Sense and one or more Solar Charger(s) is wireless: It uses VE.Smart Network – a wireless technology based on Bluetooth Smart.

Information transmitted can be used simultaneously by one, two or more Solar Chargers connected to the same 12V, 24V and 48V battery bank. The Smart Network is set up using the VictronConnect app.

Tidy, simple – smart

Installation is simple, quick and tidy. Just connect the unit’s two eyelets to your battery terminals and attach the Smart Battery Sense unit directly onto the battery-body using its self-adhesive strip.

Read more
47.63 EUR VAT included
The product is in stock
Details
6
VE.Can Power Cable
  • Brand: Victron Energy
When the CAN bus is not powered by a Skylla-I or a MPPT, you will need the new VE.Can Power Cable to supply the power.
Read more
47.63 EUR VAT included
The product is in stock
Details
7
Wall mounted enclosure for Color Control GX
  • Brand: Victron Energy
Wall mount enclosure for Color Control GX.
Read more
47.63 EUR VAT included
The product is in stock
Details
8
Active GPS Antenna
  • Brand: Victron Energy

Modem accessory for Venus-devices

Being an accessory for GX-devices, the GX GSM is a member of the GX Product family. It is a cellular modem; providing a mobile internet for the system and connection to the VRM Portal.

 
Read more
47.63 EUR VAT included
The product is in stock
Details
9
Argodiode 80-2SC 2 batteries 80A
  • Brand: Victron Energy

Diode battery isolators allow simultaneous charging of two or more batteries from one alternator, without connecting the batteries together. Discharging the accessory battery for example will not result in also discharging the starter battery.

The Argo Battery Isolators feature a low voltage drop thanks to the use of Schottky diodes: at low current the voltage drop is approximately 0,3 V and at the rated output approximately 0,45 V.

All models are fitted with a compensation diode that can be used to slightly increase the output voltage of the alternator. This compensates for the voltage drop over the diodes in the isolator.

Simply inserting the isolator in the cabling between the alternator and the batteries will slightly reduce charge voltage. The result can be that batteries are not charged to the full 100% and age prematurely.

Alternator energize input

Some alternators need DC voltage on the B+ output to start charging. Obviously, DC will be present when the alternator is directly connected to a battery. Inserting a Diode or FET splitter will however prevent any return voltage/current from the batteries to the B+, and the alternator will not start.

The new ‘AC’ diode isolators feature a special current limited energize input that will power the B+ when the engine run/stop switch is closed.

Read more
47.63 EUR VAT included
The product is in stock
Details
10
M8 circular connector Male/Female 3 pole cable 3m (bag of 2)
  • Brand: Victron Energy

M8 circular connector Male/Female 3 pole cable 3m (bag of 2)

 
Read more
47.63 EUR VAT included
The product is in stock
Details
11
Orion IP67 24/12-10A (120W)
  • Brand: Victron Energy
Completely encapsulated: waterproof, shockproof and ignition protected water, oil or dirt will not damage the Orion IP67 DC-DC Converter. The casing is made of cast aluminium and the electronics are moulded in resin.
Read more
47.63 EUR VAT included
The product is in stock
Details
12
Outdoor 2G and 3G GSM Antenna
  • Brand: Victron Energy

Modem accessory for Venus-devices

Being an accessory for GX-devices, the GX GSM is a member of the GX Product family. It is a cellular modem; providing a mobile internet for the system and connection to the VRM Portal.

Read more
47.63 EUR VAT included
The product is in stock
Details
13
Adapter Cord 32A/3 to single ph.-CEE Plug 5P/CEE Coupling 3P
  • Brand: Victron Energy

Adapter Cord 32A 3 phase to single phase

 
Read more
48.82 EUR VAT included
The product is in stock
Details
14
BatteryProtect 12/24V-65A
  • Brand: Victron Energy

The BatteryProtect disconnects the battery from non essential loads before it is completely discharged (which would damage the battery) or before it has insufficient power left to crank the engine.

The BatteryProtect is not designed for reverse currents from charging sources

12/24V auto ranging

The BatteryProtect automatically detects system voltage

Programming made easy

The BatteryProtect can be set to engage / disengage at several different voltages.
The seven segment display will indicate which setting has been chosen.

A special setting for Li-ion batteries

In this mode the BatteryProtect can be controlled by the VE.Bus BMS.
Note: the BatteryProtect can also be used as a charge interrupter in between a battery charger and a Li-ion
battery. See connection diagram in the manual.

Ultra low current consumption

This is important in case of Li-ion batteries, especially after low voltage shutdown.
Please see our Li-ion battery datasheet and the VE.Bus BMS manual for more information.

Over voltage protection

To prevent damage to sensitive loads due to over voltage, the load is disconnected whenever the DC voltage exceeds 16V respectively 32V.

Ignition proof

No relays but MOSFET switches, and therefore no sparks.

Delayed alarm output

The alarm output is activated if the battery voltage drops below the preset disconnect level during more than 12 seconds. Starting the engine will therefore not activate the alarm. The alarm output is a short circuit proof open collector output to the negative (minus) rail, max. current 50 mA. The alarm output is typically used to activate a buzzer, LED or relay.

Delayed load disconnect and delayed reconnect

The load will be disconnected 90 seconds after the alarm has been activated. If the battery voltage increases again to the connect threshold within this time period (after the engine has been started for example), the load will not be disconnected.
The load will be reconnected 30 seconds after the battery voltage has increased to more than the preset reconnect voltage.

Read more
48.82 EUR VAT included
The product is in stock
Details
15
Orion-Tr 24/12-15 (180W) DC-DC converter
  • Brand: Victron Energy

High efficiency

Using synchronous rectification, full load efficiency exceeds 95%.

IP43 protection

When installed with the screw terminals oriented downwards.

Screw terminals

No special tools needed for installation.

Models: 24 Volt

Read more
48.82 EUR VAT included
The product is in stock
Details
16
Solarcable L=10m/6sqmm MC4-M/F conn. (PV-ST01)
  • Brand: Victron Energy
Solar panel connecting cable.
Read more
48.82 EUR VAT included
The product is in stock
Details
17
BCD 402 2 batteries 40A (combiner diode)
  • Brand: Victron Energy

Diode Battery Combiners are used to guarantee continuous DC power to mission critical equipment, such as an electronic engine control system. With a diode battery combiner two or more DC power sources can be used in parallel to supply the mission critical load. Failure of one source will not interrupt power to the critical load.

The Argo Battery Combiners feature a low voltage drop thanks to the use of Schottky diodes: at low current the voltage drop is approximately 0,3 V and at the rated output approximately 0,45 V.

Warning: hot surface, mount the Argo Diode Battery Combiner on non-flammable surface only!

Read more
52.39 EUR VAT included
The product is in stock
Details
18
Busbar to connect 6 CIP100200100
  • Brand: Victron Energy

Busbar to connect 6

Read more
53.59 EUR VAT included
The product is in stock
Details
19
Current Transformer 100A:50mA for MultiPlus-II
  • Brand: Victron Energy

Current Transformer 100A:50mA for MultiPlus-II / MultiGrid-II to implement PowerControl and PowerAssist and to optimize self-consumption with external current sensing. Maximum current: 32A.

Read more
53.59 EUR VAT included
The product is in stock
Details
20
Cyrix-ct 12/24V-120A intelligent battery combiner
  • Brand: Victron Energy

Intelligent battery monitoring to prevent unwanted switching

Some battery combiners (also called voltage controlled relay, or split charge relay) will disconnect a battery in case of a short but high amperage load. A battery combiner also may fail to connect a large but discharged battery bank because the DC voltage immediately drops below the disengage value once the batteries are connected.
The software of the Cyrix-ct 12/24 does more than simply connect and disconnect based on battery voltage and with a fixed time delay. The Cyrix-ct 12/24 looks at the general trend (voltage increasing or decreasing) and reverses a previous action only if the trend has reversed during a certain period of time. The time delay depends on the voltage deviation from the trend.
(for Battery Combiners with multiple engage/disengage profiles, please see the Cyrix-i 400)

Long bolts to allow connection of more than one power cable

Cyrix 12/24-120: 13 mm (M6) Cyrix 12/24-230: 16 mm (M8)

Protection against overheating (due to a long duration overload e.g.)

The Cyrix will disengage in case of excessive contact temperature, and reengage again after it has cooled down.

LED status indication (Cyrix 12/24 230 only)
LED on: engaged LED 10 s flash: disengaged
LED 2 s flash: connecting LED 2 s blink: disconnecting
LED 0,25 s blink: alarm (over temperature; voltage > 16 V; both batteries < 10 V; one battery < 2 V)
(multiply by two for 24 V)

12/24 V auto ranging

The Cyrix-ct 12/24 automatically detects system voltage.

No voltage loss

Cyrix battery combiners are an excellent replacement for diode isolators. The main feature is that there is virtually no voltage loss so that the output voltage of alternators or battery chargers does not need to be increased.

Prioritising the starter battery

In a typical setup the alternator is directly connected to the starter battery. The accessory battery, and possibly also a bow thruster and other batteries are each connected to the starter battery with Cyrix battery combiners. When a Cyrix senses that the starter battery has reached the connect voltage it will engage, to allow for parallel charging of the other batteries.

Bidirectional voltage sensing and power supply from both batteries

The Cyrix senses the voltage of both connected batteries. It will therefore also engage if for example the accessory battery is being charged by a battery charger.
The Cyrix-ct 12/24 has a dual power supply. It will therefore also close if the voltage on one battery is too low to operate the Cyrix.
In order to prevent unexpected operation during installation or when one battery has been disconnected, the Cyrix-ct 12/24 will not close if the voltage on one of the two battery connections is lower than 2 V (12 V battery) or 4 V (24 V battery).

Parallel connection in case of emergency (Start Assist)

The Cyrix can also be engaged with a push button (Cyrix remains engaged during 30 seconds) or a switch to connect batteries in parallel manually. This is especially useful in case of emergency when the starter battery is discharged or damaged.

Read more
53.59 EUR VAT included
The product is in stock
Details
21
M8 circular connector Male/Female 3 pole cable 5m (bag of 2)
  • Brand: Victron Energy

M8 circular connector Male/Female 3 pole cable 5m (bag of 2)

 
Read more
53.59 EUR VAT included
The product is in stock
Details
22
Orion-Tr 24/12-20 (240W) DC-DC converter
  • Brand: Victron Energy

High efficiency

Using synchronous rectification, full load efficiency exceeds 95%.

IP43 protection

When installed with the screw terminals oriented downwards.

Screw terminals

No special tools needed for installation.

Models: 24 Volt

Read more
54.78 EUR VAT included
The product is in stock
Details
23
Wall mounted enclosure for Color Control GX and BMV or MPPT
  • Brand: Victron Energy

Easily mount a BMV and MPPT Control on a wall.

BMV700 and Color Control in images not included

Read more
59.54 EUR VAT included
The product is in stock
Details
24
AC Current sensor - single phase - max 40A
  • Brand: Victron Energy

Use the AC Current sensor to measure and visualise the solar production of a PV Inverter. The measurements will be visible on the GX device and on the VRM Portal.

The sensor is a simple external current sensor, which measures AC Current. Together with the voltage measurements is calculated into Apparent Power (VA) and Energy (kWh). The sensor can be wired to either the AUX input or the Temperature-input of Multi and Quattro inverter/chargers.

Read more
59.54 EUR VAT included
The product is in stock
Details
close

Compare

You must add at least one product to compare products.

close

Was added to wishlist!

Was removed from wishlist!