The new style MultiPlus is set to replace the earlier MultiPlus Compact range. It is a powerful true sine wave inverter, a sophisticated battery charger that features adaptive charge technology and a high-speed AC transfer switch in a single compact enclosure.
Uninterrupted AC power (UPS function): In the event of a grid failure, or when shore or generator power is disconnected, the inverter within the Multi is automatically activated and takes over the supply to the connected loads. This happens so fast (less than 20 milliseconds) that computers and other electronic equipment will continue to operate without disruption
Remote Monitoring and Control: Monitor and control your MultiPlus and system or systems’ locally (LAN) or remotely via the internet from anywhere in the world, using the free VRM app and free VRM portal website. Access can be from a phone, tablet, laptop or PC for multiple operating systems. There is no end to the level of control, via the required Color Control GX or Venus GX, from adjusting your MultiPlus to setting a Geofence for hire vehicles and more…
Proven reliability: The full bridge plus toroidal transformer topology has proven its reliability over many years. The inverter is short circuit proof and protected against overheating, whether due to overload or high ambient temperature.
PowerControl – Dealing with limited generator, shore side or grid power: With the Multi Control Panel a maximum generator or shore current can be set. The MultiPlus will then take account of other AC loads and use whatever is extra for charging, thus preventing the generator or shore supply from being overloaded.
PowerAssist – Boosting the capacity of shore or generator power: Where peak power is so often required only for a limited period, the MultiPlus will make sure that insufficient shore or generator power is immediately compensated for by power from the battery. When the load reduces, the spare power is used to recharge the battery. High start-up power Needed to start high inrush loads such as power converters for LED lamps, halogen lamps or electric tools
Programmable relay: By default, the programmable relay is set as an alarm relay, i.e. the relay will de-energise in the event of an alarm or a pre-alarm (inverter almost too hot, ripple on the input almost too high, battery voltage almost too low).
Voltage (V): 12 Peak Power (W) : 900 Max Efficiency: 90% Programmable Relay: Yes Dimensions: H311 x W182 x D100mm Battery Temperature Sensor: Yes Remote on-off: On/off/charger only Protection Category: IP21 Three Phase and Parallel Operation: Yes Transfer Switch (A): 16 Cont. Output Power at 25°C (VA): 500 Cont. Output Power at 25°C (W) : 430 Cont. Output Power at 40°C (W) : 400 Cont. Output Power at 65°C (W) : 300 Zero Load Power (W): 6 Zero Load Power in Search Mode (W): 2 Charge Current House Battery (A): 20 Charge Current Starter Battery (A): 1 VE.Bus Communication Port: For parallel and three phase operation, remote monitoring and system integration DIP switches: Yes Internal DC fuse : 125A
The Inverter RS Smart Solar is a combination of a powerful 48VDC, 6kVA 230VAC inverter and a high voltage, 80-450VDC, 4kW MPPT solar charger. Thanks to its modern design and high frequency technology the inverter only weighs 11kg and has an excellent efficiency, low standby power, and very quiet operation.
The inverter is equipped with a display to read out battery, inverter, and solar charger details. These parameters can also be read out via Bluetooth by the VictronConnect App. In addition to this, the inverter has a VE.Direct and a VE.Can Port, for connection to a GX device for system monitoring.
Inverter RS Smart Solar 48/6000 INVERTER DC Input voltage range 38 – 64 V Output Output voltage: 230 VAC ± 2% Frequency: 50 Hz ± 0.1% (1) Continuous output power at 25°C Increases linearly from 4800 W at 46 VDC to 5300 W at 52 VDC Continuous output power at 40°C: 4500W Continuous output power at 65°C: 3000W Peak power 9 kW for 3 seconds Short-circuit output current: 50A Maximum efficiency: 96.5% at 1 kW load 94% at 5 kW load SOLAR: Maximum DC voltage: 450V Nominal DC voltage: 300V Start-up voltage: 120V MPPT operating voltage range 80 – 450V DC input current limit: 18A Maximum DC input current: 20A Maximum PV input power: 4000W Maximum DC charging power: 4000W